Cleaning The Inside - Fujitsu FI-400F Operator's Manual

Chapter 5 Daily Care

5.3 Cleaning the Inside

The inside of the scanner should be cleaned with a piece of
cloth moistened with Cleaner F1, or a sheet of Cleaning Wipe.
ATTENTION
 To avoid deformation and discoloration, never use paint thinner or
any other organic solvents.
 Be careful not to let any moisture or water inside the scanner during
cleaning.
 It may take a long time to dry if an excessive amount is used. Use it
in small quantity. Wipe off the cleaner completely to leave no residue
on the cleaned parts.
1
Open the document cover.
For details, refer to "1.4 Opening/Closing the Document Cover" (page
18).
2
Clean the following locations with a cloth moistened with
Cleaner F1 or a sheet of Cleaning Wipe.
Plastic Frame
ATTENTION
Be careful not to let the cleaner in between the document bed and
the plastic frame.
Document Pad
Document Bed
TOP
Contents
Index
Introduction
Scanner
Overview
How to Scan
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Appendix
Glossary
40