Ipsec Secured-Tunnel Maximums; Platform Considerations; Module Requirements; References - Juniper JUNOSE 11.0.X IP SERVICES Configuration Manual

For e series broadband services routers - ip services configuration
Table of Contents

Advertisement

JUNOSe 11.0.x IP Services Configuration Guide

IPSec Secured-Tunnel Maximums

See JUNOSe Release Notes , Appendix A, System Maximums corresponding to your
software release for information about the maximum number of GRE/IPSec,
DVMRP/IPSec, and L2TP/IPSec connections supported on E Series routers.

Platform Considerations

For information about modules that support L2TP and IP tunnels with IPSec on the
ERX7xx models, ERX14xx models, and the ERX310 Broadband Services Router:
For information about modules that support L2TP and IP tunnels with IPSec on the
E120 and E320 Broadband Services Routers:

Module Requirements

To create IPSec-secured tunnels, you must install an IPSec Service module (ISM) in
the ERX router. The ISM is a security gateway and functions as one of the endpoints
for secure tunnels. The tunnel endpoints are the tunnel source and the tunnel
destination IP addresses. For an L2TP/IPSec tunnel, the source is the L2TP network
server (LNS) and the destination is the L2TP access concentrator (LAC).
For information about installing ISMs in the ERX routers, see the ERX Hardware
Guide.

References

For more information about the protocols for securing L2TP and IP tunnels with
IPSec, consult the following resources:
288
Platform Considerations
See LNS and LAC support in ERX Module Guide, Table 1, Module Combinations for
detailed module specifications.
See LNS and LAC support in ERX Module Guide, Appendix A, Module Protocol
Support for information about the modules that support LNS and LAC.
See LNS and LAC support in E120 and E320 Module Guide, Table 1, Modules and
IOAs for detailed module specifications.
See LNS and LAC support in E120 and E320 Module Guide, Appendix A, IOA
Protocol Support for information about the modules that support LNS and LAC.
RFC 2401 Security Architecture for the Internet Protocol (November 1998)
RFC 2661 Layer Two Tunneling Protocol " L2TP" (August 1999)
RFC 3193 Securing L2TP using IPSec (November 2001)
RFC 3715 IPsec-Network Address Transation (NAT) Compatibility Requirements
(March 2004)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.0.x

Table of Contents