Juniper JUNOSE 11.0.X IP SERVICES Configuration Manual page 281

show dvmrp tunnel summary
Data tx 0
1 DVMRP tunnel found
1 tunnel was created static
Example 3
host1#show dvmrp tunnel state enabled
DVMRP tunnel boston1 is up
1 DVMRP tunnel found
1 tunnel was created static
Example 4
host1#show dvmrp tunnel virtual-router vr1 ip 0.0.0.0
DVMRP tunnel boston1 is up
1 DVMRP tunnel found
1 tunnel was created static
Example 5 Displays a DVMRP tunnel on an E320 router
host1#show dvmrp tunnel detail
DVMRP tunnel v1Tunnel1 is Up (tunnel is static)
Tunnel operational configuration
Tunnel mtu is '10240'
Tunnel source address is '50.1.1.1'
Tunnel destination address is '50.1.1.2'
Tunnel transport virtual router is v1
Tunnel up/down trap is enabled
Tunnel-server location is 13/0/0
Tunnel administrative state is Up
Statistics packets
Data rx 5
Data tx 5
See show dvmrp tunnel.
Use to display a summary of information about DVMRP tunnels.
Field descriptions
Administrative status
enabled Tunnel is available for use
disabled Tunnel is not available for use
Operational status
up Tunnel is operational
down Tunnel is not operational
not-present Tunnel is not operational, because the hardware (such as
a line module) supporting the tunnel is inaccessible
Example
Chapter 9: Configuring IP Tunnels
0 0
octets
740
740
Monitoring IP Tunnels
0
discards errors
0 0
0 0
255