Table of Contents
Advertisement
JUNOSe 11.0.x IP Services Configuration Guide
or rejects the address. Because the router stops testing conditions after the first
match, the order of the conditions is critical. If no conditions match, the router rejects
the address. An empty prefix list results in an automatic permit of the tested address.
Unlike access lists, the prefix list specifies a base IP or IPv6 address and a length (the
number of bits applied to the base to determine the network prefix). The tested
address is matched against the prefix.
Use the ip prefix-list command to define an IP prefix list, or the ipv6 prefix-list
command to define an IPv6 prefix list. The prefix-list keyword with either the match
{ ip | ipv6 } address or match { ip | ipv6 } next-hop commands enables you to
add a clause to a route map.
Using a Prefix List
The following example creates a prefix list that permits routes with a prefix length
up to 24 in the 151.0.0.0/8 network:
clear ip prefix-list
clear ipv6 prefix-list
ip prefix-list
ipv6 prefix-list
34
Prefix Lists
host1(config)#ip prefix-list abc permit 151.0.0.0/8 le 24
Use to clear all hit counts in the prefix lists or the specified entry from the
specified prefix list. (The router increments the hit count by 1 each time an entry
matches.)
Example
host1#clear ip prefix-list abc
There is no no version.
See clear ip prefix-list.
Use to clear all hit counts in the IPv6 prefix lists or the specified entry from the
specified prefix list. (The router increments the hit count by 1 each time an entry
matches.)
Example
host1#clear ipv6 prefix-list abc
There is no no version.
See clear ipv6 prefix-list.
Advertisement
Table of Contents
