Juniper JUNOSE 11.0.X IP SERVICES Configuration Manual page 294

JUNOSe 11.0.x IP Services Configuration Guide
gre destination profile
profile
tunnel checksum
268
Configuring a Destination Profile for Dynamic IP Tunnels
Use to specify that the router accepts only dynamic IP tunnels protected by an
IPSec transport connection.
This command is supported in the destination profile only when you have installed
an ISM on ERX routers.
Example
host1(config-dest-profile)#enable ipsec-transport
Use the no version to disable IPSec transport mode.
See enable ipsec-transport.
Use to configure a destination profile for dynamic GRE tunnels.
Use the any-virtual-router keyword to create a default destination profile for all
virtual routers. There can only be one default destination profile defined in the
system.
Use the virtual-router keyword to specify a specific transport virtual router.
Example
host1(config)#gre destination profile kanata2
Use the no version to delete the destination profile.
See gre destination profile.
Use to assign an IP profile with parameters that are used to stack an upper IP
interface over a dynamic GRE or DVMRP tunnel to the destination profile.
Example
host1(config-dest-profile)#profile ip-kanata
Use the no version to remove the profile assignment from the destination profile.
See profile.
Use to enable checksum computation across a GRE tunnel.
Checksum computation is not supported for DVMRP tunnels.
Selecting this feature causes the E Series router to drop corrupted packets it
receives on the tunnel interface.
Example
host1(config-dest-profile)#tunnel checksum
Use the no version to disable the checksum option.
See tunnel checksum.