Juniper JUNOSE 11.0.X IP SERVICES Configuration Manual page 201

show ipsec tunnel summary
show ipsec tunnel virtual-router
inbound lifetime: allowed 7200s, remaining 7100s
inbound traffic: allowed 1024000KB, remaining 1023997KB
outboundSpi = 0x283b0201,
outbound lifetime: allowed 7200s, remaining 7100s
outbound traffic: allowed 1024000KB, remaining 1023997KB
Tunnel Statistics:
InUserPackets
InUserOctets
InAccPackets
InAccOctets
InAuthErrors
InReplayErrors
InPolicyErrors
InOtherRxErrors
InDecryptErrors
InPadErrors
OutUserPackets
OutUserOctets
OutAccPackets
OutAccOctets
OutPolicyErrors
OutOtherTxErrors
See show ipsec tunnel.
Use to display a summary of all tunnels configured on the router.
Field descriptions
Total number of ipsec interface Number of tunnels configured on the router
Administrative status Number of tunnels with an administrative status of
enabled and disabled
Operational status Number of tunnels with an operational status of up,
down, lower layer down, not present
Example
host1#show ipsec tunnel summary
Total number of ipsec interface is 40
Administrative status
Operational status up
See show ipsec tunnel.
Use to display the status of tunnels configured on a virtual router.
To display only tunnels that are in a specific state, use the state keyword.
outboundSa = esp-3des-hmac-sha
15
1920
15
2760
0
0
0
0
0
0
15
1920
15
2760
0
0
enabled disabled
40 0
down lower-down
40 0 0
Chapter 5: Configuring IPSec
not-present
0
175
Monitoring IPSec