Configuring Dynamic Ipsec Subscribers; Overview; Dynamic Connection Setup - Juniper JUNOSE 11.0.X IP SERVICES Configuration Manual

For e series broadband services routers - ip services configuration
Table of Contents

Advertisement

Chapter 6

Configuring Dynamic IPSec Subscribers

Overview

Dynamic Connection Setup

This chapter describes how to securely terminate IPSec remote access subscribers.
These subscribers can reside on different VPNs and the router can support many
VPNs simultaneously. It contains the following sections:
Overview on page 177
Platform Considerations on page 180
References on page 181
Creating an IPSec Tunnel Profile on page 181
Configuring IPSec Tunnel Profiles on page 182
Defining IKE Policy Rules for IPSec Tunnels on page 189
Monitoring IPSec Tunnel Profiles on page 190
You can use the E Series router to terminate users on multiple VPNs (that is, a private
intranet where users can log in and access private servers). For the E Series router,
VPNs appear as VRs or VRFs. Users that connect to the VPN terminate on the
associated VR or VRF. The router contains a link between the VR or VRF and the
private intranet containing the resources. This link can be a direct connection, or a
tunnel (IPSec, IP-in-IP, GRE, or MPLS). Once establishing a connection, the router
can pass traffic between the VPN and connected users.
The E Series router already supports termination of secure remote access subscribers
using L2TP and IPSec. In this model, IPSec uses transport mode to " protect" PPP
subscribers that use L2TP tunnels as described in RFC 3193. However, because they
are handled by the PPP and L2TP application, IPSec has no direct information about
the subscribers. By terminating dynamic IPSec subscribers, the IPSec protocol
manages the subscribers completely.
Dynamic secure remote access subscribers initiate connections to the E Series router
by establishing an IPSec phase 1 security association (SA; also known as an IKE SA
or P1) with the router.
After establishing a security association, the subscriber is instantiated in the IPSec
software. Following this instantiation, the router initiates the extended authentication
(Xauth) protocol exchange to invoke the user to enter a username and password.
177
Overview

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.0.x

Table of Contents