Installing and Removing Interface Cards
To prevent improper cooling and thermal damage, do not operate the IPS 4270-20 unless all expansion
Caution
slots have a cover or a card installed.
To install and remove interface cards, follow these steps:
Log in to the CLI.
Step 1
Prepare the IPS 4270-20 to be powered off:
Step 2
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note
Power off the IPS 4270-20.
Step 3
Remove the power cables from the IPS 4270-20.
Step 4
If rack-mounted, extend the IPS 4270-20 from the rack.
Step 5
Make sure the IPS 4270-20 is in an ESD-controlled environment.
Step 6
Remove the chassis cover.
Step 7
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
4-42
You can also power down the IPS 4270-20 using IDM or IME.
Chapter 4
Installing the IPS 4270-20
OL-18504-01