Advanced Setup For The Idsm2 - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Advanced Setup
AIP SSM# reset
Warning: Executing this command will stop all applications and reboot the node.
Continue with reset? []:
Enter
Step 24
Apply the most recent service pack and signature update. You are now ready to configure your AIP SSM
Step 25
for intrusion prevention.
For More Information
•
•
•

Advanced Setup for the IDSM2

To continue with advanced setup for the IDSM2, follow these steps:
Step 1 Session in to the IDSM2 using an account with administrator privileges.
•
•
Enter the
Step 2
Enter
Step 3
Step 4 Specify the Telnet server status.
You can disable or enable Telnet services. The default is disabled.
Step 5 Specify the web server port.
The web server port is the TCP port used by the web server (1 to 65535). The default is 443.
Note
Step 6 Enter
Current interface configuration
Command control: GigabitEthernet0/2
Unassigned:
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
10-20
to continue the reboot.
yes
For the procedure for obtaining the most recent IPS software, see
page 11-1.
For the procedure for using HTTPS to log in to IDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following guides:
Installing and Using Cisco Intrusion Prevention System Device Manager 7.0
–
Installing and Using Cisco Intrusion Prevention System Manager Express 7.0
–
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
–
7.0
Catalyst software
console> enable
console> (enable) session module_number
Cisco IOS software
router# session slot slot_number processor 1
command. The System Configuration Dialog is displayed.
setup
to access advanced setup.
3
The web server is configured to use TLS/SSL encryption by default. Setting the port to 80 does
not disable the encryption.
to modify the interface and virtual sensor configuration.
yes
Chapter 10 Initializing the Sensor
Obtaining Cisco IPS Software,
Logging In to IDM.
OL-18504-01