Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 185

Chapter 9 Logging In to the Sensor
Session to the module.
Step 2
asa# session 1
Opening command session with slot 1.
Connected to slot 1. Escape character sequence is 'CTRL-^X'.
You have 60 seconds to log in before the session times out.
Enter your username and password at the login prompt.
Step 3
Note
login: cisco
Password:
***NOTICE***
This product contains cryptographic features and is subject to United States and local
country laws governing import, export, transfer and use. Delivery of Cisco cryptographic
products does not imply third-party authority to import, export, distribute or use
encryption. Importers, exporters, distributors and users are responsible for compliance
with U.S. and local country laws. By using this product you agree to comply with
applicable laws and regulations. If you are unable to comply with U.S. and local laws,
return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to export@cisco.com.
***LICENSE NOTICE***
There is no license key installed on the system.
Please go to http://www.cisco.com/go/license to obtain a new license or install a license.
AIP SSM#
Step 4 To escape from a session and return to the adaptive security appliance prompt, do one of the following:
• Enter
• Press CTRL-Shift-6-x (represented as CTRL^X).
For More Information
For the procedure for using the setup command to initialize the AIP SSM, see
•
the AIP SSM, page
OL-18504-01
The default username and password are both
time you log in to the module. You must first enter the UNIX password, which is
you must enter the new password twice.
.
exit
10-16.
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
. You are prompted to change them the first
cisco
Logging In to AIP SSM
. Then
cisco
Advanced Setup for
9-7