Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 164

Installation and Removal Instructions
Always use the ejector levers when installing or removing the IDSM2. A module that is partially seated
Caution
in the backplane causes the system to halt and subsequently crash.
If you perform a hot swap, the console displays the message
Caution
message does not appear, however, if you are connected to the Catalyst 6500 series switch through a
Telnet session.
Step 9 Use a screwdriver to tighten the installation screws on the left and right ends of the IDSM2.
Step 10 Verify that you have correctly installed the IDSM2 and can bring it online.
Step 11 Initialize the IDSM2.
Configure the switch for command and control access to the IDSM2.
Step 12
Upgrade the IDSM2 to the most recent Cisco IDS software.
Step 13
Set up the IDSM2 to capture IPS traffic. You are now ready to configure the IDSM2 for intrusion
Step 14
prevention.
For More Information
For more information on ESD-controlled environments, see
•
1-32.
For the procedure for verifying the IDSM2 installation, see
•
For the procedure for using the setup command to initialize the IDSM2, see
•
page
For the procedure for configuring the switch for command and control access to the IDSM2, refer
•
to
• For the procedure for obtaining and installing the most recent IPS software, see
Software, page
• For the procedure for configuring the IDSM2 to capture IPS traffic, refer to
• For the procedure for using HTTPS to log in to IDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following guides:
•
–
–
–
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
7-8
10-1.
Configuring the Catalyst 6500 Series Switch for Command and Control Access to the
11-1.
Installing and Using Cisco Intrusion Prevention System Device Manager 7.0
Installing and Using Cisco Intrusion Prevention System Manager Express 7.0
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
7.0
Chapter 7 Installing the IDSM2
Module x has been inserted
Working in an ESD Environment, page
Verifying Installation, page
Initializing the Sensor,
Obtaining Cisco IPS
Configuring the
Logging In to IDM.
. This
7-9.
IDSM2.
IDSM2.
OL-18504-01