Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 204

Advanced Setup
[2] Save this configuration and exit setup.
Enter your selection[2]:
If you receive the warning that Analysis Engine is initializing, enter
far and exit setup. You can then reenter setup and press Enter until you are back to the interface and
virtual sensor menu.
Step 7 Enter
Modify interface/virtual sensor configuration?[no]: yes
Current interface configuration
Command control: Management0/0
Unassigned:
Monitored:
GigabitEthernet0/1
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
[1] Edit Interface Configuration
[2] Edit Virtual Sensor Configuration
[3] Display configuration
Option:
Enter
Step 8
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
No Interfaces to remove.
Unassigned:
Monitored:
[1] GigabitEthernet0/1
Add Interface:
Step 9 Enter
Add Interface: 1
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
Monitored:
GigabitEthernet0/1
[1] Edit Interface Configuration
[2] Edit Virtual Sensor Configuration
[3] Display configuration
Option:
Press Enter to exit the interface and virtual sensor configuration menu.
Step 10
Modify default threat prevention settings?[no]:
Enter
Step 11
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
10-14
to modify the virtual sensor configuration.
2
to edit the virtual sensor vs0 configuration.
2
to add GigabitEthernet0/1 to virtual sensor vs0.
1
if you want to modify the default threat prevention settings.
yes
Chapter 10 Initializing the Sensor
to save your configuration thus
2
OL-18504-01