Installation And Removal Instructions - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Chapter 5 Installing the AIM IPS
For More Information
•
•
•

Installation and Removal Instructions

For instructions on how to install and remove the AIM IPS, refer to the following documents:
•
•
•
Perform the following tasks after installing the AIM IPS:
1.
2.
3.
4.
For More Information
•
•
•
•
•
•
OL-18504-01
For more information on the IPS CLI, refer to
Sensor Using the Command Line Interface
For more information on IDM, refer to
Device Manager 7.0.
For more information on IME, refer to
Manager Express 7.0.
Cisco 1800 Series Hardware Installation Guide (Modular)
For instructions, refer to "Installing and Upgrading Internal Modules in Cisco 1800 Series Routers
(Modular)."
Cisco 2800 Series Hardware Installation
For instructions, refer to "Installing and Upgrading Internal Modules in Cisco 2800 Series Routers."
Cisco 3800 Series Hardware Installation
For instructions, refer to "Installing and Upgrading Internal Components in Cisco 3800 Series
Routers."
Verify that the AIM IPS is installed properly.
After you install the AIM IPS, you must initialize it.
After you initialize the AIM IPS, you should make sure you have the latest IPS software.
Configure the AIM IPS to receive IPS Traffic.
For the procedure for verifying that the AIM IPS is installed properly, see
page 5-6.
For the procedure for using the setup command to initialize the AIM IPS, see
page 10-1.
For more information about obtaining the most recent Cisco IPS software, see
Software, page 11-1.
For the procedure to configure the AIM IPS to receive IPS traffic, refer to
the AIM IPS and the Router.
For the procedure for using HTTPS to log in to IDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following guides:
Installing and Using Cisco Intrusion Prevention System Device Manager 7.0
–
Installing and Using Cisco Intrusion Prevention System Manager Express 7.0
–
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
–
7.0
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Configuring the Cisco Intrusion Prevention System
7.0.
Installing and Using Cisco Intrusion Prevention System
Installing and Using Cisco Intrusion Prevention System
Logging In to

Installation and Removal Instructions

Verifying Installation,
Initializing the Sensor,
Obtaining Cisco IPS
Setting Up Interfaces on
IDM.
5-5