Replacing The 4Ge Ssm; Installing And Removing The Sfp Modules; Sfp Module; Installing The Sfp Module - Cisco ASA 5505 Hardware Installation Manual

Installing and Replacing the 4GE SSM

Replacing the 4GE SSM

The following is only supported on the ASA 5510, ASA 5520, and ASA 5540.
Note
To replace an existing 4GE SSM, perform the following steps:
Step 1 Enter the hw-mod mod 1 shut command in privileged EXEC mode. Verify that the module is down by
making sure that the LEDs are all off.
Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist, so that it contacts your bare
skin. Attach the other end to the chassis.
Step 3 Remove the two screws at the left rear end of the chassis.
Remove the 4GE SSM. Place it in a static bag and set it aside.
Step 4
Replace the existing card by inserting the new 4GE SSM through the slot opening.
Step 5
Attach the screws to secure the 4GE SSM to the chassis.
Step 6
Enter the hw-mod mod 1 reset command in privileged EXEC mode to reset the 4GE SSM.
Step 7
Check the LEDs. If the 4GE SSM is installed properly, the POWER LED is solid green and the STATUS
Step 8
LED is flashing during boot up.
Connect the RJ-45 cable to the port and the other end of the cable to your network devices. For more
Step 9
information, see the

Installing and Removing the SFP Modules

Note The following is supported on the ASA 5510, ASA 5520, ASA 5540, and ASA 5550.
The SFP is a hot-swappable input/output device that plugs into the SFP ports. The following SFP module
types are supported:
•
•
This section describes how to install and remove the SFP modules in the adaptive security appliance to
provide optical Gigabit Ethernet connectivity. It contains the following topics:
•
•
•
Cisco ASA 5500 Series Hardware Installation Guide
A-4
"Connecting the Interface
Long wavelength/long haul 1000BASE-LX/LH (GLC-LH-SM=)
Short wavelength 1000BASE-SX (GLC-SX-MM=)
SFP Module, page A-5
Installing the SFP Module, page A-6
Removing the SFP Module, page A-7
Appendix A
Cables" section.
Installing and Replacing the SSM
78-17374-01