Connecting Interface Cables - Cisco ASA 5550 Series Getting Started Manual

Warning
Caution

Connecting Interface Cables

Step 1
Step 2
78-17644-01
Connecting Cables to Network
Interfaces
This chapter describes how to connect the appropriate cables to the Console,
Auxiliary, Management, copper Ethernet, and fiber Ethernet ports.
This chapter includes the following sections:
Connecting Interface Cables, page 4-1
•
What to Do Next, page 4-7
•
Only trained and qualified personnel should install, replace, or service this
equipment Statement 49
.
Read the safety warnings in the
the Cisco ASA 5500 Series
these steps.
To connect cables to the network interfaces, perform the following steps:
Place the chassis on a flat, stable surface, or in a rack (if you are rack-mounting it).
Connect to the Management port.
C H A P T E R
Regulatory Compliance and Safety Information for
and follow proper safety procedures when performing
Cisco ASA 5550 Getting Started Guide
4
4-1