Configuring The Idsm2 Maintenance Partition For Catalyst Software - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Chapter 12 Upgrading, Downgrading, and Installing System Images
•
•

Configuring the IDSM2 Maintenance Partition for Catalyst Software

To configure the IDSM2 maintenance partition, follow these steps:
Log in to the switch CLI.
Step 1
Enter privileged mode.
Step 2
console# enable
console(enable)#
Step 3 Reload the IDSM2.
console> (enable) reset module_number cf:1
Session to the IDSM2.
Step 4
console# session 9
Trying IDS-9...
Connected to IDS-9.
Escape character is '^]'.
Cisco Maintenance image
Note
Log in as user
Step 5
Note
login: guest
Password: cisco
Maintenance image version: 2.1(2)
guest@idsm2.localdomain#
View the IDSM2 maintenance partition host configuration.
Step 6
guest@idsm2.localdomain# show ip
IP address
Subnet Mask
IP Broadcast
DNS Name
Default Gateway : 10.89.149.126
Nameserver(s)
guest@idsm2.localdomain#
OL-18504-01
For the procedure for configuration the maintenance partition on IDMS-2, see
IDSM2 Maintenance Partition for Catalyst Software, page 12-31
Maintenance Partition for Cisco IOS Software, page
For the procedure for initializing the IDSM2, see
You cannot Telnet or SSH to the IDSM2 maintenance partition.You must session to it from the
switch CLI.
and password
guest
You can change the guest password, but we do not recommend it. If you forget the maintenance
partition guest password, and you cannot log in to the IDSM2 application partition for some
reason, the IDSM2 requires an RMA.
: 10.89.149.74
: 255.255.255.128
: 10.255.255.255
: idsm2.localdomain
:
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
12-35.
Advanced Setup for the IDSM2, page
.
cisco
Installing System Images
Configuring the
and Configuring the IDSM2
10-20.
12-31