Verifying The Status Of The Aip Ssm; Installing The Aip Ssm - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Installation and Removal Instructions
Insert the AIP SSM through the slot opening.
Step 4
Attach the screws to secure the AIP SSM to the chassis.
Step 5
Power on the adaptive security appliance by pushing the power switch at the back of the chassis.
Step 6
Check the indicators. If the AIP SSM is properly installed, the POWER indicator is solid green and the
Step 7
STATUS indicator is flashing green. You can also verify that the AIP SSM is online using the show
module 1 command.
Initialize the AIP SSM.
Step 8
Install the most recent Cisco IPS software.
Step 9
Configure the AIP SSM to receive IPS traffic.
Step 10
For More Information
•
•
•
•
•
•

Verifying the Status of the AIP SSM

You can use the show module 1 command to verify that the AIP SSM is up and running.
The following values are valid for the Status field:
•
•
•
•
•
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
6-4
For more information about ESD, see
For the procedure for verifying that the AIP SSM is properly installed, see
the AIP SSM, page 6-4.
For the procedure for using the setup command to initialize the AIP SSM, see
Sensor, page 10-1.
For the procedure for obtaining the latest Cisco IPS software, see
page 11-1.
For the procedure for configuring the AIP SSM to receive IPS traffic, refer to
AIP SSM.
For the procedure for using HTTPS to log in to IDM, refer to
—The AIP SSM is being detected and the control communication is being initialized
Initializing
by the system.
—The AIP SSM has completed initialization by the system.
Up
—The system encountered an error communicating with the AIP SSM.
Unresponsive
—The AIP SSM is reloading.
Reloading
—The AIP SSM is shutting down.
Shutting Down
LI NK LI NK
SP D SP D
LI NK LI NK
3 3
SP D SP D
LI NK LI NK
2 2 SP D SP D
LI NK LI NK
1 1 SP D SP D
0 0
Working in an ESD Environment, page
Logging In to
Chapter 6

Installing the AIP SSM

FL AS H
1-32.
Verifying the Status of
Initializing the
Obtaining Cisco IPS Software,
Configuring the
IDM.
OL-18504-01