Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual page 67

Chapter 2 Installing the IPS 4240 and the IPS 4255
Note
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate
Step 10
power by moving the handle of the circuit breaker to the ON position.
Replace the DC power supply plastic shield.
Step 11
Power on the IPS 4240-DC from the switch at the back of the chassis.
Step 12
Note If you need to power cycle the IPS 4240-DC, wait at least 5 seconds between powering it off and
powering it back on.
Initialize the IPS 4240-DC.
Step 13
Upgrade the IPS 4240-DC with the most recent Cisco IPS software.
Step 14
You are now ready to configure intrusion prevention on the appliance.
For More Information
DC power guidelines are listed in
•
Intrusion Prevention System 4200 Series Appliance
• For more information on working with electrical power and in an ESD environment, see
Safety Guidelines, page
For the procedure for placing IPS 4250-DC in a rack, see
•
• For the procedure for using the setup command to initialize IPS 4250-DC, see
page
For the procedure for updating IPS 4250-DC with the most recent cisco IPS software, see
•
Cisco IPS Software, page
For the procedure for using HTTPS to log in to IDM, refer to
•
For the procedures for configuring intrusion prevention on your sensor, refer to the following guides:
•
–
–
–
OL-18504-01
The DC return connection to this system is to remain isolated from the system frame and chassis.
1-30.
10-4.
11-1.
Installing and Using Cisco Intrusion Prevention System Device Manager 7.0
Installing and Using Cisco Intrusion Prevention System Manager Express 7.0
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
7.0
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Regulatory Compliance and Safety Information for the Cisco
Sensor.
Rack Mounting, page
Installing the IPS 4240-DC
2-6.
Basic Sensor Setup,
Logging In to IDM.
Site and
Obtaining
2-13