Version Information; Understanding The Show Version Command; Displaying Version Information - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Gathering Information
Total Broadcast Packets Transmitted = 0
Total Jumbo Packets Transmitted = 0
Total Undersize Packets Transmitted = 0
Total Transmit Errors = 0
Total Transmit FIFO Overruns = 0
MAC statistics from interface Management0/0
Interface function = Command-control interface
--MORE--

Version Information

The show version command is useful for obtaining sensor information. This section describes the show
version command, and contains the following topics:
•
•

Understanding the show version Command

The show version command shows the basic sensor information and can indicate where a failure is
occurring. It gives the following information:
•
•
•
•
To get the same information from IDM, choose Monitoring > Sensor Monitoring > Support
Note
Information > Diagnostics Report. To get the same information from IME, choose Configuration >
sensor_name > Sensor Monitoring > Support Information > Diagnostics Report.

Displaying Version Information

Use the show version command to display version information for all installed operating system
packages, signature packages, and IPS processes running on the system. To view the configuration for
the entire system, use the more current-config command.
To display the version and configuration, follow these steps:
Log in to the CLI.
Step 1
Step 2 View version information.
sensor# show version
Application Partition:
Cisco Intrusion Prevention System, Version 7.0(1)E3
Host:
Signature Definition:
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
A-74
Understanding the show version Command, page A-74
Displaying Version Information, page A-74
Which applications are running
Versions of the applications
Disk and memory usage
Upgrade history of the applications
Realm Keys key1.0
Signature Update S383.0
Chapter A
2009-02-20
Troubleshooting
OL-18504-01