Cisco SPA942 - - IP Phone Administration Manual page 182

9
180
• sub—Use this keyword to identify the phones to be monitored). Its value and
syntax is stationName@$PROXY, where system variable $PROXY contains the
proxy server IP and port (e.g. 192. 1 68.8. 1 01:6060).
• usr or ext—Use one of these keywords to identify the specific users or
extensions to be monitored. Its value and syntax is extensionNumber@$PROXY,
where system variable $PROXY contains the proxy server IP and port (e.g.
192. 1 68.8. 1 01:6060).
• nme (optional)— Use this field with the SPA9000 to identify any alias that has
been assigned to the extension in the SPA9X2 phone configuration.The nme
parameter indicates the extension name, which in this case is the same as the
station name.
• vid (optional)— All LEDs on the SPA932 use phone extensions that they are
assigned to. By default, LEDs on the SPA932 are assigned to the first
configured extension on the connected phone. You can optionally assign LEDs
to any other phone extensions using vid=keyword. Use this field to identify the
phone extension to use with the monitored list specified by the sub= keyword,
when more than one BLF monitored list is configured on the SIP proxy server.
The possible values are 1 to 6, corresponding to each of the six extensions
available on the phone. Only use the vid= keyword in the first entry assigned to
each phone extension. Subsequent keys will use the same extension. See
"SPA932 Parameter Notes" section on page
Configuring the SPA932 Attendant Console
NOTE: Unit/key LEDs will not light without the
"sub" keyword.
Cisco SPA and Wireless IP Phone Administration Guide
Setting Up the SPA932 Attendant Console
183.