Configuring SIP, SPCP, and NAT
Configuring SIP
STEP 6
STEP 1
STEP 2
STEP 3
STEP 4
Cisco SPA and Wireless IP Phone Administration Guide
Parameter
Auth INVITE
Ntfy Refer On 1xx-
To-Inv
Use Anonymous
with RPID
Set G729 annexb
Click Submit All Changes.
Configuring a SIP Proxy Server
To configure SIP proxy and registration parameters:
Log in to the web administration interface.
Click Admin Login and advanced.
Click the Extension <number> tab.
Configure the proxy and registration parameters for each extension.
Description
When enabled, authorization is required for initial
incoming INVITE requests from the SIP proxy.
NOTE:
Not applicable to the WIP310.
If set to yes, as a transferee, the phone will send a NOTIFY with
Event:Refer to the transferor for any 1xx response returned by
the transfer target, on the transfer call leg.
If set to no, the phone will only send a NOTIFY for final
responses (200 and higher).
NOTE:
Not applicable to the WIP310.
This parameter applies only if <SIP Remote-Party-ID> is set to
yes; otherwise, it is ignored.
If the parameter is set to yes, the FROM header's display-name
and user-id fields are set to anonymous when the caller blocks
his caller-id. If the parameter is set to no, the FROM header's
display-name and user-id are not masked. The Remote-Party-
ID header indicates privacy=full when the caller wishes to
block his caller-id.
Default: yes.
NOTE:
Not applicable to the WIP310.
Configure G.729 Annex B settings.
NOTE
Not applicable to the SPA525G.
5
105