Configuring The Spa932 - Cisco SPA942 - - IP Phone Administration Manual

9
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
178
In the following example, extension 3500 is used to add Subscribecontext to
point to the context. This is entered in the file sip.conf:
[3500]
type=friend
secret=3500
callerid="spa3500"<3500>
nat=no
context=home
mailbox=3500
Subscribecontext=home
...
...

Configuring the SPA932

Complete the configuration required for the extensions on your IP PBX and obtain
the following information:
• SPA9000 IP address or other hostname
• Phone extension numbers
To configure the SPA932:
Steps 1 through 4 are only required when the
These steps are not required for other server types such as BroadSoft and
Asterisk.
Connect to the web UI for the phone to which the SPA932 is connected.
Click Admin/Advanced on the web UI page.
Click the SIP tab.
Select yes from the CTI Enable
Click the SPA932 or Attendant Console tab. (If you do not see the SPA932 or
Attendant Console tab, check your firmware version, and upgrade as necessary.)
Unit 1 Enable
Select yes from the
units, also select yes from the
Configuring the SPA932 Attendant Console
Setting Up the SPA932 Attendant Console
Server Type
drop-down list.
drop-down list. If you have installed two SPA932
Unit 2 Enable
drop-down list.
Cisco SPA and Wireless IP Phone Administration Guide
field is set to SPA9000.