Breq# Signal Assertion During Power On; Peci Address Assigned To Processor - Intel BFCBASE - Motherboard - 7300 Datasheet

Data sheet
Table of Contents

Advertisement

Thermal Specifications
Table 6-9.

BREQ# signal assertion during power on

BREQ0#
Asserted
Asserted
Not asserted
Not asserted
Table 6-10
the ClusterID[1:0] and AgentID[1] setting at power on.
Table 6-10. PECI Address assigned to processor
Cluster ID[1] / APIC
The Intel® 7300 Chipset chipset assigns Agent ID, Cluster ID as listed below. When the
®
Intel
Xeon
Intel® 7300 Chipset, the following PECI device addresses are generated as shown
below:
FSB0 {Cluster ID[1:0], Agent ID[1]} = 000; PECI address 0x30
FSB1 {Cluster ID[1:0], Agent ID[1]} = 010; PECI address 0x32
FSB2 {Cluster ID[1:0], Agent ID[1]} = 100; PECI address 0x31
FSB3 {Cluster ID[1:0], Agent ID[1]} = 110; PECI address 0x33
The power-on-configuration (POC) settings of third-party chipsets may produce
different PECI addresses than those shown above. Thermal designers should consult
their third party chipset designers for the correct PECI addresses.
Please note that each address also supports two domains (Domain 0 and Domain 1).
6.3.2.2
PECI Fault Handling Requirements
PECI is largely a fault tolerant interface, including noise immunity and error checking
improvements over other comparable industry standard interfaces. The PECI client is
as reliable as the device that it is embedded in, and thus given operating conditions
that fall under the specification, the PECI will always respond to requests and the
protocol itself can be relied upon to detect any transmission failures. There are,
however, certain scenarios where the PECI is known to be unresponsive.
Document Number: 318080-002
BREQ1#
Not asserted
Asserted
Asserted
Not asserted
shows how the PECI address is assigned to each of the processors based on
ClusterID[0] /
ID[4]
APIC ID[3]
0
0
0
0
0
1
0
1
1
0
1
0
1
1
1
1
®
Processor 7200 Series and 7300 Series is used in conjunction with the
AgentID[1:0] Die 0
AgentID[1:0] Die 1
00
10
This combination is not supported by the processor
AgentID[1] / APIC
ID[2]
0
1
0
1
0
1
0
1
01
11
PECI Address
0x30
0x31
0x32
0x33
0x31
0x30
0x33
0x32
109

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xeon 7300 seriesXeon 7200 series

Table of Contents