Mounting The Panel - GE 60-806-95R-16Z - Security Concord Express System Control Panel Installation Instructions Manual

Installing the System
Table 2: Maximum Device Wire Lengths (Continued)
Device
2-Wire Smoke Detectors
Sirens
SuperBus 2000 2x16 LCD
Alphanumeric Touchpad
SuperBus 2000 Fixed Display
LCD Touchpad
SuperBus 2000 2x20 LCD
Alphanumeric Touchpad
SuperBus 2000 2x20 VFD
Alphanumeric Touchpad
SuperBus 2000 Hardwire Input
Module

Mounting the Panel

Use the following procedure to mount the panel to the wall or wall studs.
Make sure you are free of static electricity whenever you work on the panel with the
!
cover open. To discharge any static, first touch the metal panel chassis, then stay in con-
tact with the chassis when touching the circuit board. Using an approved grounding
strap is recommended.
Caution
¾
To mount the panel cabinet and circuit board:
1. Open the panel door and slide it up to remove it from the cabinet. Set the door aside.
2. Remove the knockout to provide access for system wiring (see Figure 2).
3. Feed all device wires through the knockout and place the panel in position against the wall.
4. Level the panel and mark the top and bottom mounting holes (see Figure 2).
Knockout
Mounting Holes
Figure 2. Mounting Holes
5. Install anchors where studs are not present.
6. Partially insert screws into the two top mounting hole locations, then hang the panel on the
two screws.
7. Recheck for levelness, insert the two lower screws, and tighten all four mounting screws.
Max. Wire Length to Panel
22 AWG—330 ft.
18 AWG—830 ft.
(based on 10 ohms maximum loop resistance
+ 2k end-of-line)
22 AWG—80 ft.
18 AWG—200 ft. when using ITI siren models
13-469 or 13-046
22 AWG—300 ft.
18 AWG— 750 ft.
22 AWG—300 ft.
18 AWG— 750 ft.
22 AWG—250 ft.
18 AWG— 600 ft.
22 AWG—250 ft.
18 AWG— 600 ft.
22 AWG—1,800 ft.
18 AWG— 4,500 ft.
Wire Type
Stranded
Stranded
Stranded
Stranded
Stranded
Stranded
Stranded
6