Table of Contents
Advertisement
Demo Kit Mode
This setting determines whether the panel is used for a standard installation
(off) or as a demo kit (on). Turning on this feature and performing a memory
clear changes the following settings:
•
System Master Code = 1234
•
User Code 00 = 1001 (standard user code capabilities)
•
User Code 01 = 1002 (standard user code capabilities, bypass sensors)
•
User Code 04 = 1122 (standard user code capabilities, system tests)
•
Zone 1 (hardwire) = Group 10, Front Door
•
Zone 2 (hardwire) = Group 13, Bedroom Window
•
Zone 3 (hardwire) = Group 17, Living Room PIR
•
Zone 4 (hardwire) = Group 01, Panic
•
Zone 5 (wireless) = Group 01, Keychain Touchpad
•
Zone 6 (wireless) = Group 13, Kitchen Window
•
COMM FAILURE = off
•
Entry Delay = 8 seconds
•
Exit Delay = 8 seconds
•
Extended Delay = 1 minute
•
Siren Timeout = 2 minutes
•
Status Beeps = on (all touchpads)
•
Central Station Reporting = sensors learned into groups 01 and 03,
Duress code use, and phone test ( 8 + CODE + 2 )
Clear Memory (System Programming)
Clearing memory with the Dealer Code deletes all existing
programming except the Dealer Code.
If the Dealer Code HAS NOT been set, clearing the memory
with the Installer Code deletes all existing programming.
If the Dealer Code HAS been set, clearing the memory with
the Installer Code deletes all existing programming except:
•
Dealer Code
•
Downloader Code
•
CS Phone 1
•
CS Phone 2
19
Settings in tier 2 menus can also be accessed by entering shortcut numbers. See the section, "Pro-
gramming Tier 2 Menu Items" for complete details.
Programming Tier 1 Menu Items
This section guides you through programming tier 1 menu items as they appear in sequence. The
exact order you need to follow will depend on whether you're installing a new system or chang-
ing the programming of an existing system.
Programming Tier 2 Menu Items
This section guides you through programming tier 2 menu items as they appear in sequence.
Each menu on tier 2 represents a group of settings related to the menu name. Refer to Figure 22
for the menus available on tier 2.
System Programming (Default = Off)
¾
To turn Demo Kit Mode On or Off:
1. With the display showing
(current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press ƒ and the display shows
OFF/ON
3. Clear panel memory to enable the demo kit
mode (see next menu).
¾
To clear Panel Memory:
1. With the system in program mode, press B until the display
shows
.
CLEAR MEMORY
2. Press ƒ and the display shows
.
ORY
3. Enter the 4-digit installer CODE (or dealer if
programmed) + ƒ .
After about one second, the system restarts and the panel scans
the bus to learn all bus devices. If the system doesn't respond as
described, repeat step 3.
DEMO KIT OFF/ON
DEMO KIT
(new setting).
System Programming
ENTER CODE TO CLEAR MEM-
Programming the Panel
Hide quick links:
Advertisement
Table of Contents
