Mounting The Panel - GE Simon Installation Instructions Manual

Note
When choosing the AC out-
let location for the AC power
transformer, make sure the
outlet is not controlled by a
switch or that it is not part of
a ground fault interrupt cir-
cuit (GFIC).
9
Press tab with thumb,
then swing cover down.
D o o r s & M o t i o n
W i n d o w s S e n s o r s S t a t u s
H O M E S E C U R I T Y
A r m D i s a r m S y s t e m
1 / 2 3 / 4 5 / 6 7 / 8 9 / 0
C O D E
S p e c i a l
D o o r s M o t i o n T i m e S e n s o r O n O f f
H O M E C O N T R O L
C h i m e L i g h t s
E M E R G E N C Y
F I R E P O L I C E A U X
T e s t W e e k l y
Figure 2. Opening the Panel Cover and Chassis

Mounting the Panel

The panel can be mounted on a wall or on the optional Tabletop Base.
1. Choose a panel location.
2. Run all necessary power, phone, siren, and hardwire contact wires to the desired
panel location.
3. Refer to Figure 3 for mounting hole locations.
For wall mounting, hold the panel against the wall and mark the mounting hole
locations with a pencil. For Tabletop Base mounting, place the panel back on the
base until the top and bottom mounting holes line up with the mounting posts on
the base.
Press tab up with
screwdriver, then
swing chassis
down.
Simon Security System