Connecting The Ac Power Transformer; Powering Up The Panel - GE 60-806-95R-16Z - Security Concord Express System Control Panel Installation Instructions Manual

Note
If you plan on connecting an
alphanumeric touchpad to
the programming touchpad
header on the panel, do not
connect it until after the
panel is powered up. Refer
to "Entering Programming
Mode."
Note
Without AC power, shut-
down will occur if battery
voltage falls below 10.2
VDC.
Installing the System
3. Check the phones on the premises for dial tone and the ability to dial out and make phone
calls. If phones do not work correctly, check all wiring and correct where necessary. Proceed
to the "Troubleshooting" section of this manual if problems persist.

Connecting the AC Power Transformer

The panel must be powered by a plug-in stepdown transformer that supplies 16.5 VAC, 25 VA
(60-822 or 60-679-CN). Connect the power transformer to the panel as shown in Figure 18.
Do not plug in the power transformer at this time. The panel must be powered up using
!
the sequence of steps described in the following section, "Power Up the Panel."
Caution
Panel Terminals
Figure 18. Connecting the Power Transformer

Powering Up the Panel

After installing SnapCards and wiring all devices to the panel, you are ready to apply AC and
backup battery power to the panel.
¾
To power up the panel:
1. Connect the red and black battery leads (included with panel) to the lugs located in the upper-
left area of the panel circuit board (see Figure 19).
Backup Battery Connections
Red
Red Black
Battery
Figure 19. Connecting the Backup Battery
2. Connect the battery leads to the battery terminals as shown.
3. Plug the transformer into an outlet that is not controlled by a switch or ground fault circuit
interrupt (GFCI).
Alphanumeric touchpads display
display. Fixed display touchpads briefly show all text, no text,
,
************ SCANNING BUS DEVICES
, then a date and time
, then a time display.
BUS SCAN
16