Facility Requirements; And 8/40 San Switch Memory; San Switch, Encryption San Switch, And Fcoe Converged Network Switch Memory; Extension San Switch Memory - HP 1606 Hardware Reference Manual

Table 18 8/8, 8/24 and 8/40 SAN Switch memory
Memory type
Main Memory (SDRAM)
Boot Flash
Compact Flash
Table 19 lists the 8/80 SAN Switch, Encryption SAN Switch, and FCoE Converged Network Switch
memory specifications.
Table 19 8/80 SAN Switch, Encryption SAN Switch, and FCoE Converged Network Switch memory
Memory type
Main Memory (DDR2 SDRAM)
Boot Flash
Compact Flash
Table 20 lists the 1606 Extension SAN Switch memory specifications.
Table 20 1606 Extension SAN Switch memory
Memory type
Main Memory (DDR2 SORDIMM SDRAM)
Boot Flash
Compact Flash

Facility requirements

To ensure correct operation, the facility where the switch is in use must meet the requirements shown
in Table 21.
Table 21 Facility requirements
Type
Electrical
86 Technical specifications
Requirements
8/8, 8/24, 8/80, Encryption, and 1606 Extension SAN Switches Primary AC input:
100–240 VAC, 2.0 A, 47–63 Hz; switch autosenses input voltage.
8/40 SAN Switch Primary AC input: 90–264 VAC; switch autosenses input voltage.
FCoE Converged Network Switch Primary AC input: 85–264 VAC; input line frequency
47–63 Hz.
Adequate supply circuit, line fusing, and wire size, as specified by the electrical rating on
the switch nameplate.
Circuit protected by a circuit breaker and grounded in accordance with local electrical
codes.
Electrical interference less than the levels in the standards listed in
Install memory
512 MB
8/40 SAN Switch only: 4 MB
1 GB
Install memory
1 GB
4 MB
1 GB
Install memory
2 GB
4 MB
1 GB
Table 22.