Download Print this page

HP 1606 Hardware Reference Manual Page 62

Hp storageworks 8-gb san switch hardware reference guide (5697-0291, july 2010).
Hide thumbs

Advertisement

LED name
LED color
Steady amber (for
more than five
seconds)
Flashing am-
ber/green
Ethernet speed
No light
Steady green
Ethernet link
No light
Steady amber
Flashing amber/no
light
Port status
No light
Slow flashing green
(flashing in 2-second
intervals)
Fast flashing green
(flashing in half-
second intervals)
Flickering green
(steady with random
flashes)
Steady green
Slow flashing amber
(flashing in 2-second
intervals)
Fast flashing amber
(flashing in half-
second intervals)
62
Managing the 8-Gb SAN Switches
Status of hardware
Faulty fan FRU or power supply
FRU, boot failed, or the system
is faulty.
NOTE:
This LED displays steady
amber during POST. This is
normal and does not indicate
a fault.
Attention is required. A number
of variables can cause this
status, including a single power
supply failure, a fan failure, or
exceeding one or more environ-
mental ranges.
Port speed is 10 Mb/sec.
Port speed is 100 Mb/sec.
There is no link.
There is a link.
There is link activity (traffic).
No signal or light carrier (media
or cable) is detected.
Port is online but segmented be-
cause of a loopback cable or
incompatible switch connection.
Port is online and an internal
loopback diagnostic test is run-
ning.
Port is online and frames are
flowing through the port.
Port is online, but has no traffic.
Port is disabled because of dia-
gnostics or the portdisable
command.
Port is faulty.
Recommended action
Verify that the fan FRU and power
supply FRU are seated correctly.
Replace the fan FRU or power
supply FRU, if necessary. If the fan
or power supply FRU is not the
problem, do the following:
1.
Connect a serial cable to the
system.
2.
Reboot the system.
3.
Check the failure message on
the console.
4.
Contact your service provider.
Check the management interface
and the error log for details on the
cause of the status. Contact your
switch service provider.
No action required.
No action required.
Verify that the Ethernet cable is
connected correctly.
No action required.
No action required.
Check transceiver and cable.
No action required.
No action required.
No action required.
No action required.
Verify that the diagnostic tests are
not running. Re-enable the port us-
ing the portenable command.
Check the management interface
and the error log for details on the
cause of status. Contact your switch
service provider.

Advertisement

   Related Manuals for HP 1606

Comments to this Manuals

Symbols: 0
Latest comments: