A Regulatory Compliance And Safety; Regulatory Compliance; Federal Communications Commission Notice For Class A Equipment; Modifications - HP 1606 Hardware Reference Manual

A Regulatory compliance and safety

Regulatory compliance

Federal Communications Commission notice for Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense. The end user of this product
should be aware that any changes or modifications made to this equipment without the approval of
Hewlett-Packard could result in the product not meeting the Class A limits, in which case the FCC
could void the user's authority to operate the equipment.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that
are not expressly approved by Hewlett-Packard Company may void the user's authority to operate
the equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods
in order to maintain compliance with FCC Rules and Regulations.

Regulatory compliance identification numbers

For the purpose of regulatory compliance certifications and identification, your product has been
assigned a unique RMN. The RMN can be found on the product nameplate label, along with all
required approval markings and information. When requesting compliance information for this product,
always refer to this RMN. The RMN should not be confused with the marketing name or model number
of the product.

Laser device

All HP systems equipped with a laser device comply with safety standards, including IEC 825. With
specific regard to the laser, the equipment complies with laser product performance standards set by
government agencies as a Class 1 laser product. The product does not emit hazardous light.
8-Gb SAN Switch Hardware Reference Guide 99