Nonport Side Led Activity For The 8/80 San Switch; Nonport Side Led Patterns During Normal Operation - HP 1606 Hardware Reference Manual

LED name

Nonport side LED activity for the 8/80 SAN Switch

Table 9 describes LEDs and recommended actions.
Table 9 Nonport side LED patterns during normal operation
LED name
Power supply
status
Fan status
LED color Status of hardware
Steady amber (for Port is receiving light or signal
more than 5 carrier at 4 Gb/s, but is not yet
seconds) online.
LED color Status of hardware
No light Power supply is not receiving
power or is off.
Steady green Power supply is operating nor-
mally.
Steady amber (for Power supply fault for one of the
more than five following reasons:
seconds)
• Power supply is switched off.
• Power cable is disconnected.
• Power supply has failed.
NOTE:
When the switch is first
powered on the power supply
status LED will show amber
until POST has completed.
No light Fan assembly is not receiving
power.
Steady green Fan assembly is operating nor-
mally.
Steady amber (for Fan fault for one of the following
more than five reasons:
seconds)
• One or more of the fans in
the fan assembly has failed.
• The fan FRU was disabled by
the user.
NOTE:
When the switch is first
powered on, the fan status
LED will show amber until
POST has completed.
Recommended action
No action required.
Recommended action
Verify that the power supply is on
and seated and the power cord is
connected to a functioning power
source.
No action required.
Do the following:
• Check the power cable connec-
tion.
• Verify the power supply is on.
• Replace the power supply FRU.
Do the following:
• Verify the fan FRU is seated.
• Verify the switch is on.
No action required.
Do the following:
• Verify the fan FRU is enabled
(use the fanenable com-
mand).
• Replace the fan FRU.
8-Gb SAN Switch Hardware Reference Guide 63