HP 1606 Hardware Reference Manual page 72

Steady green
Slow-flashing green
(on 1 second; then
off 1 second)
Fast-flashing green
(on 1/4 second;
then off 1/4 second)
Flickering green
Steady amber
Slow-flashing amber
(on 2 seconds; then
off 2 seconds)
Fast-flashing amber
(on 1/2 second,
then off 1/2 second)
GbE Optical No light
Port Status
Steady green
Flickering green
Steady amber
GbE Copper No lights (both LEDs
Port Status 2 are off)
LEDs per port -
Steady green, am-
one green, one
ber off
amber
Flickering green,
amber off
Green off, steady
amber
72 Managing the 8-Gb SAN Switches
Port is online (connected to ex-
ternal device) but has no traffic.
Port is online but segmented
because of a loopback cable or
an incompatible switch connec-
tion.
Port is online and an internal
loopback diagnostic test is run-
ning.
Port is online and frames are
flowing through the port.
Port is receiving light or signal
carrier, but is not yet online.
Port is disabled because of dia-
gnostics or the portdisable
command.
SFP or port is faulty.
Port is offline.
Port is online but has no traffic.
Port is online and frames are
flowing through the port.
Port is faulty.
Port is offline.
Port is online but has no traffic.
Port is online and frames are
flowing through the port.
Port is faulty.
No action required.
Verify that the correct device is at-
tached to the switch.
No action required.
No action required.
No action required.
Reset the port.
The
portcfgpersistentdisable
command is persistent across
reboots.
Reset the port.
Replace the SFP. with an HP SFP.
Verify that the power LED is on
and check the SFP and cable.
No action required.
No action required.
Change the SFP or reset the switch
from the workstation.
Verify that the power LED is on,
and check the SFP and cable.
No action required.
No action required.
Reset the switch from the worksta-
tion. If the problem persists, use
the other copper port or the optical
ports, or return the switch for re-
pair.