Port Side Led Activity For The 1606 Extension San Switch; Fcoe Converged Network Switch Nonport Side Led Patterns - HP 1606 Hardware Reference Manual

Table 12 describes the LEDs on the nonport side of the switch.
Table 12 FCoE Converged Network Switch nonport side LED patterns
LED name
Power supply
status
Fan status

Port side LED activity for the 1606 Extension SAN Switch

System activity and status can be determined through the activity of the LEDs on the 1606 Extension
SAN Switch. Figure 33
The LED states are as follows:
• No light
• Steady light
• Flashing light
The LEDs are either green or amber.
LED color Status of hardware
No light Power supply is not receiving
power or is off.
Steady green Power supply is operating nor-
mally.
Steady amber (for Power supply is faulty.
more than 5 NOTE:
seconds)
When the switch is first
powered on, the power
supply status LED displays
steady amber until POST
completes.
No light Fan assembly is not receiving
power.
Steady green Fan assembly is operating nor-
mally.
Steady amber (for Fan fault for one of the follow-
more than 5 ing reasons:
seconds)
•
•
NOTE:
When the switch is first
powered on, the fan status
LED displays steady amber
until POST completes.
shows the LEDs on the port side of the 1606 Extension SAN Switch.
One or more of the fans in
the fan assembly has failed.
The fan FRU has been dis-
abled.
8-Gb SAN Switch Hardware Reference Guide
Recommended action
Verify the power supply is on and
seated and the power cord is con-
nected to a functioning power
source.
No action required.
Do the following:
• Check the power cable connec-
tion.
• Verify that the power supply is
powered on.
• Replace the power supply FRU.
Do the following:
• Verify the fan FRU is seated
correctly.
• Verify the switch is powered
on.
No action required.
Do the following:
• Verify the fan FRU is enabled
(use the fanenable com-
mand).
• Replace the fan FRU.
69