4.
Assemble the outer rails.
a.
Attach the left outer rail and the right outer rail to the rear mounting brackets using two
1/4-20 hex nuts with captive star lock washers attached loosely, as shown in
Do not tighten the nuts.
Figure 16 Installing the outer rails (HP 10000 Series rack)
.
b.
Depending on the rack you are using, complete one of the following tasks:
• For an HP 10000 Series Rack, install two #10-32 x 1/2-inch Phillips panhead screws
with captive star lock washers and two #10 adapter washers in the upper and lower
holes on the right rail. Then, install two #10-32 x 1/2-inch Phillips panhead screws with
captive star lock washers and two #10 adapter washers in the upper and lower holes
on the left rail. (See
Figure 17 Assembling the outer rails (HP 10000 Series rack)
.
Figure
17.)
8-Gb SAN Switch Hardware Reference Guide
Figure
16.
39