Installing The Outer Rails (Hp 10000 Series Racks); Assembling The Outer Rails (Hp 10000 Series Racks) - HP StorageWorks 8/40 - SAN Switch Hardware Reference Manual

4. Assemble the outer rails:
a. Attach the left outer rail and the right outer rail to the rear mounting brackets, using two
1/4-20 hex nuts with captive star lock-washers attached loosely, as shown in
not tighten the nuts.
Figure 13 Installing the outer rails (HP 10000 series racks)
b. Depending on the rack you are using, complete one of the following tasks:
• For HP 10000 series racks, install two #10-32 x 1/2-inch Phillips pan-head screws with
captive star lock-washers and two #10 adapter washers in the upper and lower hole
locations of the right rail. Then install two #10-32 x 1/2-inch Phillips pan-head screws
with captive star lock-washers and two #10 adapter washers in the upper and lower
hole locations of the left rail. See
Figure 14 Assembling the outer rails (HP 10000 series racks)
40 Installing and configuring an 8-Gb SAN Switch
Figure 14.
Figure 13. Do