Installing the SAN Switch 2/8
Note:
and
4. Assemble the outer rails by completing the following steps:
Figure 17: Installing the outer rails (HP 9000 Series or comparable EIA rack)
50
This kit contains both left rails and right rails. The rails are marked with
Left
to distinguish the rails from each other.
a. Attach the left outer rail and the right outer rails to the rear mounting
brackets using (2) 1/4-20 hex nuts with captive star lock washers attached
loosely as shown in
tightened later in
Figure
17. Don't tighten them. The nuts will be
step
7.
SAN Switch 2/8 Version 3.1.x Installation Guide
Right