Table of Contents
Advertisement
Table 15.
Controller Settings (continued)
Parameter
Alternatives
BIOS Warning
All Messages
Level
Fatal Errors
SETUP from
Disabled
Flash-RAM
Enabled
Display
Off
On
Supported
2
BIOS Drives
7
CD-ROM Boot
Enabled
Disabled
Memory Test
No test
Standard
Double scan
Intensive
Chn. SCSI-A
Off
Termination
On
Auto
SCSI ID
0,1,2,3,4,5,6,7
Firmware Update
The firmware, BIOS and StorCon program of the Intel RAID Controller SRCU32 are stored in
Flash-RAM which is part of the Intel RAID Controller SRCU32 hardware. In contrast to
EPROMs, Flash-RAMs can be reprogrammed many times without the complicated UV-light
erasing procedure. Firmware, BIOS and StorCon are part of the SRC_PFW file. The file has an
extension (for example, SRC_PFW.009) which indicates the version stepping.
NOTE
This option is not available when StorCon is accessing the Intel RAID Controller SRCU32
remotely.
Intelligent Fault Bus
The Intelligent Fault Bus is an older subsystem standard, which is no longer used in modern
subsystems or backplanes. Intel RAID Controller SRCU32's Ultra/Wide Disk Array Controllers
were the last Intel RAID Controller SRCU32s supporting this standard, sometimes also called
"DEC Fault Bus."
Storage Console
Description
All Intel RAID Controller SRCU32 BIOS warnings and errors are displayed
Only fatal messages are displayed
<Ctrl> + <G> not possible
<Ctrl> + <G> allowed
<Ctrl> + <G> not displayed at system boot level
<Ctrl> + <G> displayed at system boot level
The Intel RAID Controller SRCU32 BIOS supports 2 drives under
MS-DOS
The Intel RAID Controller SRCU32 BIOS supports 7 drives under
MS-DOS
Boot from CD-ROM enabled
Boot from CD-ROM disabled
No test at all
Standard test
Double scan test
Intensive test (takes longer)
SCSI termination of the channel Off
SCSI termination of the channel On
SCSI termination according to occupied connectors
Possible SCSI IDs for the channel
101
Advertisement
Table of Contents
