Install the SDRAM
1. Insert the DIMM into the DIMM connector. Make sure the DIMM clips snap to the close
position. (Supported DIMMs are 64 MB to 256 MB ECC PC133 unbuffered SDRAM
memory).
Install the Intel RAID Controller SRCU32 in the Intel Server Board
Install the Intel RAID Controller SRCU32 into an available PCI slot. Refer to the board
documentation for details. The example below refers to the Intel SCB2 server board.
1. Shut down the computer system.
2. Turn the power off.
3. Insert the Intel RAID controller into an available PCI slot.
Use StorCon to Create a RAID Volume
1. Power on the system and press <Ctrl> + <G> when the screen below appears.
2. The following two messages will appear at the bottom of the screen:
"Intel (R) Storage Console to start after POST"
"Please wait to start Intel (R) Storage Console..."
3. When StorCon starts, it will display the Intel RAID Controller SRCU32 installed in the system.
Press <Enter> to select this controller.
38
Intel RAID Controller SRCU32 User's Guide