Raid Hardware Installation And Setup; Minimum Hardware Requirements; Installing And Removing The Sdram; Installing The Sdram - Intel SRCU32 - RAID Controller User Manual

RAID Hardware Installation and Setup

NOTE
The Intel RAID Controller SRCU32 will work in a 32-bit, 33 or 64 MHz PCI slot; however, a 64-bit
66 MHz slot is recommended for maximum performance.

Minimum Hardware Requirements

Computer with CD-ROM drive (not attached to the Intel RAID Controller SRCU32).
Computer must be on the supported hardware list. For a supported list refer to:
http://support.intel.com/support/motherboards/server/
One available PCI slot. See Note above.
PCI 2.2 compliant System BIOS.
SCSI hard drive(s) (the minimum required to meet the desired RAID level).

Installing and Removing the SDRAM

Installing the SDRAM

1. With clips A1 and A2 (see Figure 7) in the open position (position 2), insert the DIMM into the
DIMM connector (the DIMM and connector are keyed to ensure proper insertion).
CAUTION
Align the DIMM carefully to prevent damaging the conductor pads on the DIMM orthe
connector. Apply firm pressure but do not force.
2. With the thumbs positioned on each end of the DIMM and two fingers on the DIMM
connector, press the thumb and fingers firmly together until the DIMM clips snap into the close
position (position 1).
22 Intel RAID Controller SRCU32 User's Guide