Installing The Intel Raid Controller Srcu32 As An Additional Controller; No Intel Raid Controller Srcu32 Has Yet Been Configured For Unixware; An Intel Raid Controller Srcu32 Has Already Been Configured For Unixware; Installing An Operating System Onto A Host Drive Or Single Disk - Intel SRCU32 - RAID Controller User Manual

Installing the Intel RAID Controller SRCU32 as an
Additional Controller
Two cases are discussed below.
No Intel RAID Controller SRCU32 Has Yet Been Configured for
UnixWare
In this case, the Intel RAID Controller SRCU32 driver must be installed from the UnixWare
BTLD-Disk by means of the UnixWare desktop and the options "System Setup," "Application
Setup." Alternatively, this procedure can be carried out from the UnixWare shell:
"pkgadd -d /dev/ dsk/f0t" (Intel RAID Controller SRCU32 driver disk in drive 0).
An Intel RAID Controller SRCU32 Has Already Been Configured
for UnixWare
In this case, you only have to add an additional entry for the new Intel RAID Controller SRCU32.
This is carried out by the command.
/etc/scsi/pdiadd -d DRQ -v IRQ -m MEM srch
For DRQ use 0 (not necessary for PCI boards). For IRQ write the IRQ number that Intel RAID
Controller SRCU32 uses. MEM corresponds to the DPMEM address of the Intel RAID Controller
SRCU32 (which is displayed in the BIOS message of the Intel RAID Controller SRCU32 after
power up). In both cases, you have to carry out a cold boot to use the new Intel RAID Controller
SRCU32 under UnixWare.
Example:
/etc/scsi/pdiadd -d 0 -v 12 -m c8000 srch.
Then reboot of the UnixWare system. No kernel link is required because the driver will be
dynamically loaded.
Installing an Operating System onto a Host Drive or
Single Disk
NOTE
When installing UnixWare, create only one RAID device (host drive) on which the operating system
is to be installed.
1. Create and configure one RAID device from the BIOS of Intel RAID Controller SRCU32
StorCon (accessed by pressing <Ctrl> + <G>).
2. Insert UnixWare 7.1 installation diskette 1 of 2 which was included with the OS user's manual.
Installation begins.
72 Intel RAID Controller SRCU32 User's Guide