Table of Contents
Advertisement
Install Aurora software on shared storage devices
4 October 2010
b) Multiply the highest bit rate by the number of streams that are licensed on the
workstation.
c) Divide that number by 8 to and round to the nearest integer to convert Mbps to
MB.
d) Use the nal MB number in the K2 Con guration wizard s iSCSI Client
Bandwidth Input screen.
See the K2 documentation for complete instructions.
Prerequisites for this task are as follows:
Generic iSCSI, GVMLib, and SNFS software is installed on the devices.
The shared storage is mounted on the devices.
On a Conform Server, if you are using a Fibre Channel card, verify that the IP
MTU uses the same setting as other Aurora Edit clients.
1. In the
Software Deployment | Deployment Groups
group of devices to which you are deploying software.
The corresponding software deployment tasks are displayed in the Tasks list
view.
2. For the software you are installing, select the
install task.
Install Aurora software as follows:
Deploy
Managed Package
AuroraSuite x.x.x.xxx
ConformServer x.x.x.xxx
NewsShare x.x.x.xxx
3. Click the
Start Deployment
Deployment tasks run and software is uninstalled. Progress is reported and next
steps are indicated in both the Status and Details columns. If an error appears
regarding prerequisite software, install the prerequisite les on the control point
PC and then repeat this step.
4. When the Status or Details columns indicate next steps, identify the software in
the row, then do one of the following:
If Details displays a
Deploy
Action
Install
Install
Install
button.
link, continue with this procedure.
visible dialog pending
Managing Software
tree view, select the device or the
check box in the row for the
Aurora Edit Installation Guide
79
Advertisement
Table of Contents
