Table of Contents
Advertisement
Con guring the network
Network setup and implementation checklist
28
Aurora Edit Installation Guide
Task
If you have not already
done so, add your storage,
either K2 SAN or NAS, to
the system description
If you have not already
done so, con gure your
storage, either K2 SAN or
NAS, and verify that it is
operational.
If you have Aurora Edit
LD systems on the
corporate LAN, add the
corporate LAN to system
description
Add a group for your Edit
devices to the system
description
Add a placeholder device
to the system description
for each of your actual Edit
devices
Con gure the names of the
placeholder devices
Con gure the network
interfaces of the
placeholder devices
Install SiteCon g support
on devices if necessary.
Set credentials on devices
if necessary.
Discover your Edit devices
Assign each discovered
device to its placeholder
device
For each discovered and
assigned device, edit each
network interface. Specify
network settings and apply
them to the device.
Instructions
Refer to the K2 SAN
Installation and Service
Manual. For NAS, follow
procedures for K2 Nearline
SAN.
Comment
Modify your existing
system description.
Modify your existing
system description.
Specify IP address ranges
and other network details
If a device connects to
multiple networks, set the
control network interface
IP address rst. Also set
the hostname.
4 October 2010
Advertisement
Table of Contents
