Table of Contents
Advertisement
Adding Aurora Edit LD workstations for software deployment
4 October 2010
Setting...
Network
Address
Allocation
IP Address
The networks listed in the Edit IP Address dialog box are those currently
de ned in the system description, with available settings restricted according
to the network de nition. If you require settings that are not available, you
can close dialog boxes and go to the
modify network settings, then return to the Edit IP Address dialog box to
continue.
8. When you have veri ed that the planned settings are correct, click
to apply settings to the device and close.
A Contacting Device message box reports progress.
9. After con guring control network settings, do the following
a) If a message informs you of a possible loss of communication, click
This message is normal, since this is the network over which you are currently
communicating.
b) In the Device list view, observe the device icon and wait until the icon displays
the green star overlay before proceeding.
The icon might not display the green star overlay for several seconds as
settings are recon gured and communication is re-established.
c) In the Interface list view, right-click the interface and select
The Ping Host dialog box opens.
If ping status reports success, the interface is communicating on the control
network.
If you have Aurora Edit LD workstations on the corporate LAN, use this topic to get
the workstations communicating with SiteCon g in order to support software
deployment. Do not attempt to use device discovery.
For redundant SAN B side any network interface of type
iSCSI
iSCSI (Secondary Redundant) is required
Static is required.
The IP address for this interface on the network. Required.
Network Configuration | Networks
Con guring the network
tab to
, then
OK
Yes
.
OK
.
Ping
Aurora Edit Installation Guide
53
Advertisement
Table of Contents
