Table of Contents
Advertisement
Modifying Edit device managed network interfaces
4 October 2010
Prerequisites for this task are as follows:
The physical device you are con guring has been discovered and is assigned to a
device in the SiteCon g system description.
SiteCon g has communication with the device.
The device is de ned in the system description with an appropriate network
interface.
Use this task to modify managed network interfaces on a Aurora Edit devices as follows:
Aurora Edit
Conform Server
DSM
FTP Server
SmartBin Server
1. In the Interfaces list view determine the interface to con gure, as follows:
Identify the interface with which SiteCon g is currently communicating,
indicated by the green star overlay icon. This should be the control network
interface.
Verify that the interface over which SiteCon g is currently communicating is
in fact the interface de ned for the control network in the system description.
If this is not the case, you might have the control network cable connected to
the wrong interface port. The control connection should always be the rst port
on the motherboard, except when you have a loopback connection.
Con gure the control network interface rst before con guring any of the other
interfaces.
After you have successfully con gured the control network interface, return to
this step to con gure each remaining interface.
2. In the Interfaces list view, check the icon for the interface you are con guring.
If the icon has a red stop sign overlay, it indicates that current settings and
planned settings do not match or that there is some other problem. Hover over
the icon to read a tooltip with information about the problem.
3. In the Interfaces list view, right-click the interface you are con guring and select
.
Edit
The Managed Network Interface Details dialog box opens.
Con guring the network
Aurora Edit Installation Guide
49
Advertisement
Table of Contents
