GRASS VALLEY AURORA EDIT - INSTALLATION V7.1 Installation Manual page 24

Installing Aurora Edit Hardware
Assigning a COM Port (Windows)
To verify that the COM port is set correctly in the Windows Device Manager:
1. Right-click on
2. Click the
3. Click the * symbol next to the Ports item.
4. Click on
5. Click the Port Settings tab on the Properties tab and click
6. Select the correct
7. Click
Assigning a COM Port (Aurora Edit)
To use any of the controllers, you need to assign a speci c Aurora Edit COM port for
the controller. Aurora Edit has pre-con gured COM ports as follows:
COM
Port
1
2
3
4
5
6
To assign a COM port:
1. In the Aurora Edit application, choose the
24 Aurora Edit Installation Guide
My Computer
tab on the
Hardware
.
Manager
JLCooper USB to Serial (COM#)
COM Port Number
to close the
OK Advanced
GPIO Aurora Playout GPIO
RS-422 Video Tape Recorder (VTR)
RS-422 Jog/Shuttle Controller
USB Motorized Fader Controller
USB Effects Controller
bring up the Controller window.
and select .
Properties
window and then click
System Properties
and select
Properties
.
window, and again to close the
Tools | Options | Controller
Device
.
.
Advanced
window.
Properties
pulldown to
4 October 2010