Configurable Options - Cisco AS5350XM Configuration Manual

Configuring Basic VoIP
If you have ISDN PRI voice ports, be sure to complete the
page
T1 CAS Signaling
Channel-associated signaling (CAS) occurs in-band within the data channel, rather than on a separate
signaling channel as is the case (on the D channel) with ISDN PRI. For T1 CAS, specify parameters such
as frame type and line code.
Configure Dial Peers
Your next step in preparing to set up dial peers is to determine the configurable options that you want to
enable.

Configurable Options

Configurable options are the attributes to be applied to calls handled using that dial peer. These typically
include, at a minimum, required quality of service, codec for voice encoding, and whether voice-activity
detection is to be enabled. The following attributes, for example, are typical in a VoIP dial peer:
req-qos best-effort
codec g711ulaw
vad
You have many options and great flexibility in configuring dial peers.
most common configurable options that you can enable in POTS and VoIP dial peers, respectively, from
config or config-dial-peer mode.
Table 16
Command
answer-address
application
calling-number
default
destination-pattern
digit-strip
direct-inward-dial
exit
forward-digits
huntstop
incoming
info-digits
information-type
max-conn
no
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
8
6. Configure signaling types and, if necessary, set parameters unique to specific countries.
POTS Dial-Peer Configuration Commands
"Configuring E1 R2 Signaling" section on
Purpose
Sets call destination number.
Sets selected application.
Sets calling number (for fgd_eana signaling only).
Sets a command to its defaults.
Sets full E.164 telephone number.
Strips digits from the POTS dialed number.
Sets called number as final call destination.
Exits dial-peer configuration mode.
Configures the destination digits ahead of this dial peer.
Stops hunting on dial peers.
Sets incoming called number.
Prepends info digits to the calling number.
Sets information type for dial peer.
Sets maximum connections per peer; "no" sets to unlimited.
Negates a command or sets its defaults.
Configuring Voice over IP
Table 16 and Table 17 show the