Cisco AS5350XM Configuration Manual page 112

Configuring Alarms
Configure
Command
Step 1
AS5350> enable
Password: password
AS5350#
Step 2
AS5350# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5350(config)#
Step 3
AS5350(config)# facility-alarm detect
interface [interface type] [slot/port]
Step 4
AS5350(config)# facility-alarm detect
controller [t1 | e1 | t3] [slot/port]
Step 5
AS5350(config)# facility-alarm detect
modem-board [slot]
Step 6
AS5350(config)# facility-alarm detect rps
Step 7
AS5350(config)# facility-alarm detect
temperature
Step 8
AS5350(config)# facility-alarm detect fan
Step 9
AS5350(config-if)# Ctrl-Z
AS5350#
Verify
To see the status of the alarms, enter the show facility-alarm command:
AS5350# show facility-alarm
gigabitethernet 0/0 UP
Modem Card 4
Facility Alarm is ON
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
10
Device State
------ -----
UP
Continuing Configuration Using the Command-Line Interface
Purpose
Enters enable mode and enters the password. You
are in enable mode when the prompt changes to
or .
AS5350# AS5400#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
AS5400(config)#.
Turns on the facility alarm when an interface goes
down. Enters the interface type and slot/port
designation.
Turns on an alarm when the controller goes down.
The slot values range from 1 to 7. The port values
range from 0 to 7 for T1 and E1. The port value is
always 0 for T3.
Turns on an alarm when the modem board present
in the specified slot fails.
Turns on alarm when RPS failure event is
detected. Any of the following failures turns on
the alarm:
Input power voltage failure
•
Output power voltage failure
•
Overvoltage condition
•
Multiple failures
•
Turns on an alarm if a thermal failure event is
detected.
Turns on an alarm if a fan failure event is detected.
Returns to enable mode.
or