Cisco AS5350XM Configuration Manual page 69

Basic Configuration Using the Command-Line Interface
•
For configuration information about leased-line or nondial use, see the Cisco IOS Configuration
Note
Fundamentals Configuration Guide for your software release.
You can install a maximum of two T1 feature cards, two E1 feature cards, or one channelized T3 (CT3)
Note
feature card in a single Cisco AS5350XM or Cisco AS5400XM chassis.
Controller Numbering
The T1 and E1 controller numbering convention is slot/port in CLI commands. Feature card slot
numbering starts from the motherboard and works up from left to right. Slot 0 is reserved for the
motherboard. T1 or E1 feature card slots are numbered sequentially from 1 to 7. Port numbering is from
0 to 7.
Configure
Command
Step 1
AS5400> enable
Password: password
AS5400#
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Step 3
AS5400(config)# controller [t1 | e1]
slot/port
AS5400(config-controller)#
Step 4
AS5400(config-controller)# framing esf
Step 5
AS5400(config-controller)# linecode b8zs
Step 6
AS5400(config-controller)# Ctrl-Z
AS5400#
Mix and match channels supporting ISDN PRI, channel grouping, and robbed-bit signaling across
the same T1 line. For example, on the same channelized T1 you can configure the pri-group
timeslots 1-10,24 command, channel-group 11 timeslots 11-16 command, and ds0-group 17
timeslots 17-23 type e&m-fgb command. This is an unusual configuration because it requires you
to align the correct range of timeslots on both ends of the connection.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Configuring T1 and E1 Feature Cards
Purpose
Enters enable mode. Enters the password. You
have entered enable mode when the prompt
changes to or
AS5350# AS5400#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
AS5400(config)#.
Enters controller configuration mode to configure
your controller slot and port. Slot values range
from 1 to 7. Port values range from 0 to 7 for T1
and E1.
Enters the telco framing type: esf or sf.
Enters the telco line code type: ami or b8zs.
Returns to enable mode.
.
or
9