Cisco AS5350XM Configuration Manual page 133

Managing and Troubleshooting the Universal Port and Dial-Only Feature Cards
AS5400(config)#
Press the Enter key to make the changes and then type Ctrl-Z to return to privileged EXEC mode.
Step 9
AS5400(config)# Ctrl-Z
AS5400#
Save your changes when ready.
Step 10
AS5400# copy running-config startup-config
Using SPE Firmware Bundled with Cisco IOS Software
Use this procedure to update SPE firmware on the SPEs in your gateway if you decide to use the version
of SPE firmware bundled with Cisco IOS software instead of the version already mapped to your ports.
To set the SPE firmware mapping to the SPE firmware version bundled with Cisco IOS software, enter
the following commands:
Enter the enable command.
Step 1
AS5400> enable
Enter your password.
Step 2
Password: password
AS5400#
You are in privileged EXEC mode when the prompt changes to
Step 3 Enter global configuration mode by typing the configure terminal command.
AS5400# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
AS5400(config)#
You are in global configuration mode when the prompt changes to
Enter SPE configuration mode, which is similar to line configuration mode. You can choose to delete the
Step 4
configuration for a single SPE or range of SPEs by specifying the first and last SPE in the range. The
SPE firmware used by the SPEs automatically reverts to the version bundled with the current Cisco IOS
image.
AS5400(config)# spe slot/spe
or
AS5400(config)# spe slot/spe slot/spe
You are in SPE configuration mode when the prompt changes to
AS5400(config-SPE)#
If the previous download was unbundled firmware, enter the no form of the firmware location command
Step 5
to revert to the default Cisco IOS bundled SPE firmware:
AS5400(config-SPE)# no firmware location
Type the exit command to exit SPE configuration mode.
Step 6
AS5400(config-SPE)# exit
.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Upgrading SPE Firmware
or
AS5350# AS5400#.
or
AS5350(config)# AS5400(config)#
or
AS5350(config-SPE)#
.
19