Cisco AS5350XM Configuration Manual page 86

Configuring the Universal Port and Dial-Only Feature Cards
Table 6
Feature
Carrier protocols
Error-correcting link-access protocols V.42 LAPM, MNP 2-4
Compression protocols
Command interface
In-band signaling or tone generation
and detection
Other
Configure
Configure the lines and ports to allow users to dial in to your network.
Command
Step 1
AS5400> enable
Password: password
AS5400#
Step 2
AS5400# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
AS5400(config)#
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
26
Modem Standards and Supported Features
Description
ITU V.23 at 75/1200 bps
Telcordia Technologies 103 at 300 bps
ITU V.21 at 300 bps
ITU V.22 at 1200 bps
Telcordia 212A at 1200 bps
ITU V.22bis at 2400 bps
ITU V.32 up to 9600 bps
ITU V.32bis up to 14,400 bps
V.32 turbo up to 19,200 bps
V.FC up to 28,800 bps
V.34 up to 28,800 bps
V.34+ up to 33,600 bps
TIA/ITU V.90
K56flex
V.42bis (includes MNP 5)
Superset of the AT command set
DTMF generation
DTMF detection
MF generation
MF detection
Out-of-band access for management
PPP and SLIP framing
Basic Configuration Using the Command-Line Interface
Purpose
Enters the enable command. Enters your
password. You are in privileged EXEC mode when
the prompt changes to
AS5350#
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
AS5350(config)#
or .
AS5400#
or .
AS5400(config)#